Before you can put up your electric fence, there are a few preparations you must do.

1. The very first thing you must do is measure the parameter of the garden. It is important to plan to have a foot space between the edge of the garden and any plants that are close to the edge. You will use this measurement to determine how much electrical wire you will need and approximately how many metal stakes you should get.

2. Gather the necessary parts for the electric fence. They are listed below.

Materials Needed:
~Electric Fence Wire
~Electric Power Box (Select the best one that suits your gardening needs)
~Metal Stakes
~Grounding Post
~Plastic Hooks (2 per metal stake)
~8 Round Plastic Rings and 8 pieces of wire approximately 24 inches long (Corner connectors)
~Sledge Hammer/Pile Driver
~Wire Cutter
~Gloves

 

1) Lay out the metal stakes around the parameter of the garden. They should be spaced about three to five feet apart. Adjust to best fit your garden.
a) While laying out the metal stakes, you should also put two plastic hooks on them. These should be 4 and 6 inches away from the ground.

          TIP : The corner metal stakes will use the round plastic pieces instead of the plastic hooks.

2) Once the stakes are laid out, use the sledge hammer and/or pile driver to drive the metal stakes into the ground. The type of tool you use will depend on the size of the metal stake and personal preference.

 

 

Step three is all about the wire.

1) To begin, you will need to wind the wire around a post as illustrated in the first photograph below.

          TIP : It is easiest to start on a corner post.

2) Carefully unwind the electrical wire until the next post.

3) Thread the wire between the two prongs of the plastic hook. (See the second photograph below) Repeat this step until you are back at your beginning post.

4) Once you are back at the starting post, use a round plastic piece and thread a scrap piece of wire through the round plastic piece. Next, thread the electrical fence wire around the round plastic piece (See the third photograph below.)

          TIP:  If desired, regular plastic hooks may be used on the corner metal stakes but they need to be placed so the
wire cannot come loose.

5) Wrap the two ends of the fence wire together. You should have one single piece of electrical wire running along the parameter of your garden.

3) Repeat this process for the second round of wiring.

 

 

Setting up the connection

          TIP : Most electrical boxes require an electricity outlet. Depending on your situation, the following step can be altered to
your personal needs.

1) Depending on where you decide to put your electrical box, hammer the grounding post somewhere nearby.

WARNING: DO NOT PLUG IN THE ELECTRICAL BOX! Plugging in the electrical box CANNOT happen until all of the steps are completed. There is a high risk of being shocked.

2) With a piece of the electrical wire, connect the grounding post to the knob on the electrical box that says “Ground.” (See the photograph below)

          TIP : Without the grounding post, the electricity does not have anywhere to flow. This helps complete the
electrical circuit.

3) With a separate piece of wire, connect the knob on the electrical box that says “Fence” to the electrical fence. (See the photograph below)

 

 

Final check

WARNING: Make sure the electrical box is NOT plugged in. There is potential for electrical shocks.

1) Walk around your garden and inspect for anything that might disrupt the current. This can include grass that is too tall or a stick that fell onto the wire. These items need to be removed from the electrical wire.

 

 

Plug in the Electrical Box

1) Plug in the electrical box. Once you plug in the electrical box, you will hear a small clicking sound. This means that it is sending electricity to the fence.

TIP : Make sure you never touch the fence while the electrical box is plugged in. Always unplug the electrical box before
removing items from the fence to avoid shocks.