WASHER AND DRYER HOOKUP AND INSTALLATION SERVICE
Few household appliances are more important than your washer and dryer. Between the time they save and the way they keep your clothes looking great, they are a vital part of your day-to-day life.
To keep them working great and avoid damage to your home, it's important that your washer and dryer hookup is done properly. If you do have problems, it's important to schedule a fast repair or replacement to avoid bigger problems and keep your clothes in top shape. Services offers a full range of repair and installation services to keep your washer, dryer, and other home appliances running smoothly.*
WASHER AND DRYER INSTALLATION & HOOKUPS
Installing a washing machine and dryer may seem like a simple plug-and-play task, but that just isn't the case. To begin with, you need to figure out how to get the appliance home and up or down your stairs. Next, you need to make sure your electrical outlets can handle the electric load. This may not be the case even if you had an older model that might have used less electricity. Then, you need to get the water lines just right to avoid flooding your home either the first time you run your washer or if the connection wears out over time. Your exhaust vent also needs to be just right to allow heat and moisture to escape your home without allowing for a potential fire-causing lint buildup. If your washer or dryer uses gas, add on the need to set up the connection safely to prevent dangerous gas leaks.
Any single error can cause damage to your new appliance or to your home. It's also possible to put your safety or your family's safety at risk. To protect your purchase, yourself, and your family, leave the installation to the professionals at Services.
Petro expert installing a washer and dryer
Petro washing machine and dryer repair
If your washer or dryer are making strange noises, not running as expected, or just not cleaning right, call for service immediately. One small problem can wear out other parts in your system and spread to a bigger and more expensive problem.
Common signs that your washer needs help include the following:
Not starting
Door or lid not locking
Not spinning
Not completing a cycle
Not draining
Excessive or unusual noises
Leaking water
Starting to smell
Leaving clothes unusually wet
Common signs of trouble for a dryer include the following:
Not starting
Not spinning
Not heating
Not finishing a cycle
Not drying completely when lightly loaded
Starting to smell
Not venting properly
If you're experiencing any of the above symptoms, stop using your washer or dryer until you're able to have it checked by a professional.
Need help?
Services is the name that your neighbors have counted on for appliance installation and repair services for years. We install, maintain, and repair all major brands using only experienced technicians, including: Maytag, Whirlpool, GE, Samsung, Kenmore, and more.
We provide a full range of washer and dryer services including the following:
Removal of old appliances
Hook up of water and drainage
Installation of dryer exhaust vent
Installation of gas line for gas dryer
Installation of new unit
We recommend undertaking regular routine maintenance to keep your appliance running efficiently.
Clean the fluff filter. This filter is usually located at the front of the porthole, most commonly you would remove this by lifting the filter, noting that this will gather a lot of loose fabric which can fall away.
Pull the loose fabric away and dispose. For a through clean we recommend taking a vacuum cleaner nozzle to it filter unit and carefully vacuum around the filter cavity.
In a condenser dryer it is also important to remove fluff from the heat exchanger. This is usually located in the base of the appliance. We recommend unclipping the unit and rinsing this with a shower head or tap to remove the build-up of lint.
Appliances do vary so we recommend downloading your User Manual to get accurate information on how to clean and maintain your appliance. Some models will have a water reservoir that should be emptied prior to cleaning the exchanger.
Condenser dryers have a water container that collects the condensed water. It is important to empty this after each use though most appliances will not operate if this is full. Some models can have a hose attached to send waste water out of the standpipe. To find out whether your appliance has this feature, please refer to the user manual.
Tumble dryers are more effective if the fabric has room to move, always pay attention to care labels noting that new appliances may not work as your previous appliance did. Please check the user manual before drying delicate items.
Tips for Proper Washer and Dryer Maintenance
We all have to do laundry. Learn how to care for and maintain your washer and dryer so they last and work properly. Check out these maintenance tips.
Taking towels out of dryer
There they stand those faithful servants, our washer and dryer, waiting stoically for their next use. They’re sturdily built, simple to use and only moderately expensive. If properly maintained, they’ll give you years of service. It only takes some simple steps to extend the lifetime of your appliances and minimize washer and dryer repair costs.
7 AUTOMATIC WASHER MAINTENANCE TIPS
Home washers come in two basic models: front loaders and top loaders. Though initially more expensive, front loaders tend to pay for themselves, as they use about two thirds less water than the less expensive top loaders. Whatever your model, the following maintenance tips for your automatic washer can help prolong its life.
1. Empty the Washer of Wet Clothes As Soon As Possible
This is one of the easiest — and most essential — washer maintenance steps to perform. Left in the washer, wet clothes create unpleasant odors and can cause mold and mildew buildup if they sit for too long.
Related: What To Do When Your Washer Won't Drain
2. Inspect the Door
Another simple tip is to check the front loader door gaskets for moisture. When wetness is present, it can cause mold and mildew to accumulate, which can prevent the door from sealing properly during the wash cycle. Wipe the gaskets dry after every use and leave the door open slightly, so air can circulate and dry remaining moisture. While you’re at it, clean the gaskets and drum every month with a solution of equal parts water and vinegar. And for a top loader, leave the door open after each washing to foster air circulation and prevent mildew.
3. Don’t Overload the Washer
Oversized loads can lead to poor wash results, damaged clothing and damage to the washer as a result of the machine being off balance. For most fabrics, the machine should be loosely filled rather than packed tight.
Related: Am I Using Too Much Laundry Detergent or Cleaner?
4. Perform Periodic Maintenance Washes
Two to three times a year, run the washer without any clothes in the drum. Run on the hottest cycle using the normal amount of detergent. These regular maintenance washes will keep the machine and drain pipes clean and free from dirt, grease and hard-water salts buildup.
5. Keep the Machine Level
Check to make sure the machine is level so the drum is balanced when it spins. Spinning out of balance places a strain on parts and can significantly reduce the longevity of your washer. Most washers use adjustable legs with locking nuts for leveling. (Note: Turn the legs clockwise to lower them and counter-clockwise to raise them.) Adjust and tighten these legs to balance the machine. Some machines also have back legs that adjust automatically. Once you’ve adjusted the front legs, tilt the machine forward to allow the back legs to balance out.
6. Inspect the Hoses
Unattended, a burst water hose can spill hundreds of gallons an hour into your home. To prevent this calamity, inspect your hoses several times a year. If you see cracks or breaks, unplug the machine, turn off the water supply on both hoses and replace them, preferably with braided, metal hoses that can’t split open. Also, use a bristle brush to clean the filters of debris and sediment that reduce the machine’s water flow. Finally, replace your hoses every five years and tape the date on them so you know when you last replaced them.
7. Don’t Forget the Exterior
To prevent rusting, fill in scratches and gashes with touch-up paint from your local hardware or home supply store. Use a mild soap to wash the outside surfaces as well as the buttons and control dials to prevent sticking and malfunctions. That goes for your dryer, too.
6 Home Dryer Maintenance Tips
By all means, don’t neglect that trusty dryer standing there by the washer. It’s a bit less complicated than your washer, but it, too, needs preventive maintenance to run smoothly.
1. Clean the Lint Trap
Lint can be lethal for you and your dryer. A dryer can erupt in flames if lint builds up in either the lint screen or the ducts. According to the National Fire Protection Association, an estimated 16,800 fires were caused by dryers or washing machines in the United States. This led to civilian deaths, injuries, and millions of dollars in direct property damage. After every load, remove and clean the lint screen and use a long brush or hand vacuum to remove any globs of lint at the bottom of the trap. Shine a flashlight into the trap to make sure it’s clear. As a homeowner, it is beneficial to have a prevention plan in place in the event of a fire in your home.
Related: Need To Vent? A Guide To Cleaning Your Dryer
2. Clean the Dryer’s Venting Duct
At least once a year, clean your dryer’s entire venting system, from the dryer to the outside. If the duct is plastic or ribbed metal, toss it and replace with smooth metal. And make sure the outside vent is free of obstructions. If this task seems a bit beyond your DIY capabilities, hire a professional.
3. Don’t Put Soiled Items in the Dryer
To keep the interior of the dryer clean and the machine running efficiently, don’t put anything soiled into the dryer. If you want to put clothes or towels that are wet for some other reason — a day at the pool or beach, perhaps — run them through your washer first.
4. Don’t Overload the Dryer
This is good advice for your dryer, as well as your washer. You may think you can cram your dryer with more than one load and save time, but the opposite is true. Your clothes need the circulation of hot air to dry, and overstuffing impedes this circulation and increases the drying time. Plus, overloading the dryer can cause it to break down.
5. Use Liquid Fabric Softener
Though dryer sheets are cheaper, they leave residue in the dryer that can clog vents and reduce dryer efficiency. Liquid fabric softener, used during the washing cycle, is better for your dryer.
Related: New Appliance Checklist: Washer And Dryer Sets
6. Don’t Forget to Balance the Dryer
Like your washer, the dryer needs to be balanced for maximum performance and longevity. Use the adjustable leveling legs to even out the machine. If your dryer doesn’t have these, use uniformed-sized wood pieces to level it.
Basic washer and dryer maintenance isn’t all that difficult. No matter your level of appliance care expertise, you can save yourself some stress and money by following these simple steps for washer and dryer upkeep. Be good to them, and they’ll be good to you for years to come.
Take Your Washer and Dryer Maintenance Even Further
You depend on your laundry appliances to keep your life moving smoothly. An American Home Shield® Washing Machine Warranty and Dryer Home Warranty can help to ensure your laundry appliances are running smoothly, too
Manufacturer-approved tumble dryer repairs in Nairobi
Hire tumble dryer engineers near you to get your appliance up and running again
Guaranteed tumble dryer service for any brand and modelBringing all tools and common spare parts on-siteSkilled and City & Guilds-certified techniciansFlexible booking options
Hassle-free tumble dryer repair service completed in 4 simple steps
1.Schedule your dryer repair appointment online and get a free quote
2.Your appliance will be diagnosed by a City & Guilds-certified engineer
3.He will use suitable tools and spare parts to fix the problem on-site
4.The expert troubleshoots your appliance to ensure it’s working properly
A range of tumble dryers fixed for you by local engineers
If you notice that your tumble dryer is not working as it should, let facilitate a start-to-finish appliance repair service for you. The certified electrical or Gas Safe-registered engineers, we’ve partnered with, are experienced in fixing all appliance models and brands, such as AEG, Beko, Bosch, Hotpoint, LG, and Miele. They are able to quickly diagnose and troubleshoot any issue in full compliance with all industry standards and safety regulations.
So, schedule an appointment online when you need to fix any of the following household or commercial appliances:
Vented tumble dryers;
Condenser tumble dryers;
Heat pump tumble dryers;
Electric and gas tumble dryers;
Freestanding and integrated appliances.
Your local tumble dryer engineer can repair all kinds of common dryer faults
Your experienced technician can handle all common tumble dryer malfunctions in a day’s work. Of course, he is also trained in identifying and fixing issues that would fly past a regular technician's radar. Below, you will find a few examples of what exactly he can help you with.
The tumble dryer won’t heat up
If your appliance fails to properly heat up or does not heat at all, then the engineer can help you and identify the heating element that needs replacing. For example, this malfunction may be caused by a faulty thermostat or a thermal overload cut-out (a heat-activated fuse inside the appliance).
The appliance is not spinning
This could mean one of three things – a problem with the dryer drive belt, a seized dryer drum, or a faulty motor or capacitor. The specialist will have a closer look at your appliance to determine which of these scenarios has occurred and will order a replacement part if needed.
The machine is not drying clothes properly
This may be caused by disrupted airflow. To repair your dryer, the specialist will examine your vented or condenser tumble dryer to identify the fault. For vented models, this is usually caused by a warped or kinked vent hose, and for condenser types – by excess fluff, covering the condenser itself.
The tumble dryer is making a loud noise
If your clothes dryer makes squeaking, screeching, scraping, or banging noise, the specialist will seek the problem in faulty bearings, faulty door seal or worn tension pulleys. A solution to the issue might be something as simple as levelling the machine on a flat surface. But if this is not the case, the tumble dryer fixer will replace the faulty part.
Why opt for the Fantastic Services' tumble dryer service in Nairobi ?
Long-term results provided by professionals in the field
The professional, who will arrive to fix and extend the life of your appliance, is accredited by the City and Guilds of Nairobi Institute. This means that the engineer will perform your tumble dryer repair quickly, reliably and in line with the latest safety standards in the field.
Tumble dryer repairs with a 1-year guarantee
After the repair work is done, its quality will be guaranteed for a one-year period. This guarantee covers repairs carried out on all models by any tumble dryer brand and the parts used in the process.
Fixed price rates – you only pay for the service itself
Your price quotation will include the price for the diagnostics and repair work. It will not, however, include the cost of parts that need to be changed or ordered separately.
Providing all tools and common spare parts on-site
The toolkit of your local Nairobi technician contains all tools needed to disassemble your appliance if needed. He will also bring spare parts and use them to try and fix the issue in a single visit. If extra parts need to be ordered, a second visit will be arranged.
